Site Information

 Loading... Please wait...
  • Veratron LinkUp Analog to NMEA 2000 Gateway [B00042201]

Veratron LinkUp Analog to NMEA 2000 Gateway [B00042201]

$99.99 $89.99
(You save $10.00)

Product Description

LinkUp Analog to NMEA 2000 Gateway

The resistive-type LinkUp gateway provides an easy method to convert vessel and engine information to NMEA 2000.

Easily installed, the LinkUp Gateway replaces the original wiring, delivering power to both the LinkUp device and sensor from the NMEA 2000 backbone while still being complaint with the NMEA 2000 certification requirements. 

Configuring the LinkUp Gateway is simple using a mobile device and the companion LinkUp Configuration App for Android or IOS.

Each device has a built-in passive NFC antenna, so the parameters of the sensors are wirelessly configured to type, instance and warning threshold on the mobile device which is then "tapped" against the LinkUp device for instant data download. 


  • User-friendly configuration through wireless interface and companion smartphone App
  • Sensor Cable length - 25cm
  • NMEA 2000 Cable length - 25 cm
  • Tap to download parameters
  • Mobile App for Android or IOS
  • No power required to program
  • No certification required
  • Bi-directional communication, programming interface or data recovery

Supported Sensors:

  • Fuel Level
  • Oil/Boost Pressure
  • Fresh/Waste Water Level
  • Oil/Gear Oil/Coolant Temperature
  • Trim Tabs
  • Rudder Angle

Technical Specifications:

  • Standard M12 NMEA 2000 plug
  • LED Notification 
  • Operating Voltage - 6 - 16.5V
  • Nominal Voltage - 12 V (from NMEA 2000 network)
  • IPX7 Rated
  • Sensor Plug - Superseal Female 2 Pin
  • Counterpart Sensor Plug - - Superseal Male 2 Pin

*Sold as an Individual 

Brochure (pdf)

Product Videos

Veratron LinkUp gateways 01:17

UPGRADE YOUR ANALOGUE SENSORS TO NMEA 2000® The veratron LinkUp gateways bring your analogue sensors to the NMEA 2000® network era. All your boat’s data are now digitally available to be displayed on any NMEA 2000® enabled device. Available in 5 variants to serve different scenario: - Generic resistive (level sensors, temperature sensors, pressure sensors, …) - Pyrometer - Intelligent Battery Sensor (IBS) - Combined Temp/Press sensor - J1939 All NMEA 2000® certified! PLUG-AND-PLAY INSTALLATION The standard Micro-C M12 connector perfectly interfaces with the NMEA 2000® network without the need of additional adapters. No dedicated power supply is required, the LinkUp gateway gets its power directly from the NMEA 2000® network! The embedded LED notifies you the status of the device and its configuration at any time, reducing commissioning and troubleshooting time. WIRELESS CONFIGURATION The configuration of the LinkUp devices has never been so easy. Launch the App and define your settings through the user-friendly interface, then simply hold your mobile device in proximity of the LinkUp to transfer the configuration. Thanks to the embedded passive antenna the configuration can be done powerless! Discover more on www.veratron.comThe LinkUp Configurator is your veratron companion App to wirelessly configure your LinkUp gateway device in a snap. Discover more on For additional information contact us at

  • Veratron LinkU...
  • AMI unboxes Ve...
    AMI unbox and discuss Veratron's new Linkup Gateway, one modul...

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

Find Similar Products by Category

Click the button below to add the Veratron LinkUp Analog to NMEA 2000 Gateway [B00042201] to your wish list.